Search All Yachts
20 metres on deck, with a 15 metre on water line, this extraordinary sailing yacht is one of the last Gaff Cutters built in Scotland, and one of the nicest classic yachts to take part successfully in International Classic Yacht Races. The keel is a single solid piece of teak on which is bolted lead ballast of 16 tons. The teak deck is still original more than 90 years after construction with the exception of a few pieces and is fastened directly to the beams.
The interior fittings are in varnished mahogany. The interior was restored to its original state in 1992, and can accommodate 6 people in 3 double cabins in the original layout.
To ensure safety and ease of handling JULIETTE is equipped with Barient selftailing winches, 3 of which are electric (1 for the mainsail, 2 for the genoa), the mainsail, genoa and staysail are on furlers. Well-equipped to anchor in safety with 2x 100 m chains of 16 and 14 mm and a powerful 3500W Lofrans windlass.
The Gardner 6-cylinder, 10-litre displacement engine auxiliary engine is cooled by a fresh water circuit circulating with a heat exchanger outside on the port side of the hull. The auxiliary engine is fed by a 400 l fuel tank (refurbished in 2020). The generator set tank of 125 litres and the auxiliary tank of 80 litres, have a transfer pump that can feed the auxiliary engine if necessary.
The stainless steel drive shaft with variable pitch propeller on the starboard side, was replaced by Hundested in 2009.
Specifications
The interior fittings, mostly restored to their original state in 1992, can accommodate 6 people in 3 double cabins in the original layout.
- At the foot of the mahogany companionway in the centre of the yacht, a small passageway leads to starboard to the owner’s cabin and to port to a toilet.
- Forward, the galley is located on the port side; through the toilet room accessible on the starboard side is an engine room where the generator and the charger/inverter are located. The remainder of the former crew quarters has been converted into a double cabin forward of the galley.
- At the very front, behind a watertight door, the double chain storage.
- The engine is placed in the axis of the boat at the front of the mast and is consequently in the galley with the electrical panel positioned above the engine box.
- At the back of the companionway, and occupying the whole width of the boat: the saloon and the double cabin at the back.
- The deck house, which overlooks the cockpit and the helm station, is also accessible from this aft cabin, which allows access to the helm station from inside the boat in heavy weather without having to go through the deck.
In order to continue sailing safely in the years to come, it was necessary to ensure the structural soundness of the bilge and the frames ends and to replace the damaged metal floors, which are more than 90 years old, so that the hull could regain its original reliability. As this inspection and the necessary replacements required the removal and dismantling of a large amount of equipment to gain access to the bottom of the boat, it was decided to take advantage of this to carry out a more complete restoration, including the recaulking and painting of the hull, the overhaul of the mast, a complete overhaul of the electrical installation and the improvement of various equipments. The Gardner engine showed such weaknesses after the first few trips out of the yard that it was decided to replace it with a similar, but new model after 60 years of service. This work began in 2019 and was completed at the end of 2021 when the new engine was installed. The importance of the work and the irruption of Covid, which caused months of downtime due to the closure of the site, explain the duration of this work campaign.
Now used for pleasure boating, often only the owner and his wife, JULIETTE is equipped with the corresponding facilities:
• For short-handed manoeuvring with the mainsail, genoa and staysail furlers and the Barient self-tailing winches, 3 of which are electric (1 for the mainsail, 2 for the genoa).
• To anchor in safety with 2 chains of 100 m of 16 and 14 mm and a powerful windlass Lofrans of 3500 W.
• For a pleasant stay on board with 2 toilets and 2 electric marine macerator toilets, a pressurised water system, a water heater and a 6 places dishwasher.
• The electrical equipment is powered by a service battery bank of 16 LiFePo4 Lithium cells delivering 300A at 24V and two Optima batteries for engine starting. They are powered by a Dynamica mini 40 generator and managed by a Victron Quatro 5000w inverter/combo charger.
• The wardrobe of 3 sails provides 270 m² of upwind sail area:
• 96m² battened mainsail, in spectra covered with taffeta
• 31 m² dacron genoa, on Profurl ED 52 furler controlled from the helm station
• Double ply dacron staysail of 43 m², on manual furler (a curved track in front of the mast makes it self-tacking).
• The 12.7 mm single strand NS22 Norseman rigging was replaced in the USA in 1989.
• The mast and rigging have been systematically inspected and overhauled every 10 years.
• Auxiliary engine Gardner 6-cylinder, 10-litre displacement engine cooled by a fresh water circuit circulating with an exchanger placed outside on the port side of the hull. A 6LB model developing 125 HP at 1100 rpm replaces since the end of 2020 the old 6LWS model of 96 HP placed in 1959.
• The auxiliary engine is fed by a 400 l fuel tank (refurbished in 2020). The generator set tank of 125 litres + the auxiliary tank of 80 litres, have a transfer pump that can feed the auxiliary engine if necessary.
• The stainless steel drive shaft, which ends in a variable pitch propeller on the starboard side, was replaced by Hundested in 2009, manufacturer of the system.
HOW PRETTY POLLY WAS BORN
Sir Thomas Kennedy Laidlaw, Privy-Council for Scotland of H.M. George V, formerly owner of Lufra, desiring a new boat, entrusted the George Lennox Watson firm (who had designed Britannia), with the design of the future Pretty Polly, this is 1928, the 505 A design is drawn up by R.J. Barnett. And construction entrusted to the Robertson shipyard.
For some time in the King's entourage , the Robertson shipyard has been relied upon because the King recommended this shipyard because of an emergency repair done to Meteor, a yacht of his cousin the Kaiser, with which the two monarchs were very pleased and in thanks , not wanting any honors, Robertson asked for a "good word" for potential clients. The anecdote and documented in an article in Classic Boat from June 2008, but which was told to me by David Hutchinson, a descendant of Alexander Robertson.
The request was; "I would like a beautiful, comfortable, fast boat that will stand up well to winter storms in Scotland, when it is ready call me." This was told to me by Caroline Corbalis daughter of Thomas, granddaughter of T.K. Laidlaw. The sail number 11, chosen because it was an auspicious number for T.K. and the name Pretty Polly and that of the horse T.K. admired most, a mare belonging to his friend Major Eustache Loder, like him a racehorse breeder (Pretty Polly is still considered one of the 10 best racehorses of all time).
Please note, Pretty Polly was baptized to the Royal Yacht Squadron.
HOW SHE BECAME MOONBEAM
In the aftermath of the war, during a regatta in the Solent, Colin Mac Neil saw his Moonbeam overtaken with no power to resist by Pretty Polly. After the regatta, in the Squadron Saloons, he met Robert (Robin) Laidlaw, and asked him to call him on the day he wanted to sell Pretty Polly, and so Pretty Polly became Moonbeam Junior, and then Moonbeam, when Mac Neil sold the first Moonbeam.This was told to us by Gordon, Colin Mac Neil's son.
The company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change or withdrawal without notice.
Listing MLS by Yachtr.com
Not all boats listed online are listed with United, but we can work on your behalf. For more information on this vessel or to schedule a showing, please contact a United Yacht Sales broker by calling our main headquarters at (772) 463-3131.
SELL YOUR YACHT WITH UNITED
United is the largest professional yacht brokerage firm in the world with over 200 yacht brokers in our network. By listing your boat or yacht for sale with us, all of our team are immediately notified of your boat and begin working to match your yacht with a buyer. We have many examples where boats have sold through our network and our proprietary broker forum that keeps our team connected 24/7. With hundreds of closings every year, there is no better team than United to help with the listing and sale of your vessel. Find out what your current yacht is worth on today's market!
FINANCE NOWBUY A YACHT WITH THE UNITED TEAM
The yacht MLS consists of thousands of available brokerage vessels from all over the world and in different conditions. Hiring an experienced yacht broker to help you find the perfect boat makes financial sense, as well as takes the stress out of the process. A United broker starts by listening to your needs, how you plan to use your boat, your potential boating locations, and your budget. We then go to work looking at all of the available yachts that fit your criteria, research their history, provide you with a clear picture of the market, and organizes the showings. We're with you every step of the way from survey to acceptance and our industry-leading support staff will make sure your closing goes smoothly.